Flash Pasteurization System
Flash Pasteurization
The Flash Pasteurization System (FPS) gently pasteurizes beer, beer mix drinks and carbonated beverages. The product is first regeneratively heated and then heated to the pasteurization temperature via a hot water circuit. After passing the holding pipe, the product is cooled down regeneratively and further cooled with glycol or ice water.
The process is well established in the brewing and beverage industry in order to guarantee a long shelf life with consistent high product quality. The product is microbiologically stabilized while maintaining the required pasteurization units without negatively affecting quality characteristics such as color and taste. The high operational reliability and the high heat recovery of up to 95 % are further advantages of our flash pasteurization system.
Advantages and functions
- Very gentle pasteurization of beer and carbonated beverages
- Exact control of programmed pasteurization units (PU)
- High heat recuperation up to 95%
- Wide capacity range of 40 – 100 % of nominal capacity
- Hygienic design, full CIP capability
- Easy operation, low maintenance effort, long service life
- Fully automatic operation with standard PLC and touch panel
- Optional integration in process control system and remote maintenance
- Individually dimensioned and designed for each specific application
- Equipment and components according to customer specification
- Compact tubular-frame system (skid mounted)
Technical Description
The product is first regeneratively heated and then heated to the pasteurization temperature via a hot water circuit. Temperature and flow rate are controlled in relation to each other in order to keep the pasteurization units within very narrow limits. After passing the holding pipe, the product is cooled down regeneratively and further cooled with glycol or ice water
The two centrifugal pumps in serial arrangement in the inlet of the system keep the product pressure well above the saturation pressure at pasteurization temperature; the contained CO2 remains completely in solution. Due to the third booster pump between regeneration and heater, the pressure in the pasteurized product is always higher than in the non-pasteurized product in order to avoid contamination due to leakage. If the filler stops, a controlled product discharge with degassed water takes place by means of media separation by volume or conductivity. If filling runs up again, the deaerated water is discharged again with the product.
The unit can be controlled by a local PLC with a touch panel or by a process control system.
Designed for high hygienic standards, all common cleaning agents in the brewing and beverage industry can be used for CIP cleaning.
Technical Specifications
Capacity |
15 to 500 hl/h / 1,5 to 50 m3/h |
Pasteurization units |
according to customer specification |
Heat recovery |
up to 95 % |
Heating media |
steam or hot water |
Cooling media |
glycol or ammonia |
Contact us
Do you have any questions?
Contact Engineering
Dr. Lukas Karst
Project Engineering
Phone: +49 6122 / 70 75 - 0
Email lukas.karst@corosys.com